Peoplesoft Component Processor Flow

By -



Comments

Post a Comment

Popular posts from this blog

Peoplesoft SFTP

By -
Image
Transferring a file using SFTP to specified target location: (Thanks to Jawahar who helped me in this article) A lot has been mentioned about sFTP support in PT 8.51. Below gives clear idea on SFTP. Are there any specific pre-requirements for using file transfer protocols? Yes. Though FTP can be used directly by giving the URL as a string to the peoplecode method, other protocols (ftps, sftp, http and https) require the URL to be passed as a URL identifier only. When an URL identifier is created, URL properties link on the page gets enabled. Users need to provide the URL properties specific to the protocol they are using on this "URL properties" page. The URL properties differ based on the protocol choosen. Once URL Identifier is ready, it can be used in any of the file attachment peoplecode methods just like the existing way.   What are the authentication methods supported for sftp? Password and Public Key authentication are supported. ...
Read more

Peoplesoft Error: All Processing Suspended: Restart OPRID=PS, RUNID=RUN01, PI=5000(108,503)

By mymithraa -
All Processing Suspended: Restart OPRID=PS, RUNID=RUN01, PI=5000(108,503) What is this about and what should be done? This error can occur when Application Engine programs are restartable and run via the Process Scheduler, and the last run was No Success - And an attempt re-run, rather than re-start will produce error as well The cause of this message is that previously this same AE program was run using the same OPRID=PS & RUNID=RUN01. It was not Successful on initial run, and now an attempt to RUN the same program has occurred, instead of an attempt to RESTART the original that failed. Whether this error Happened in Development??? This message happened while the Customer was in Development phase of this AE program. It could have happened when this AE was in Production as well. However, what to do would have completely different emphasis depending on if this happens in Development or Productions. During the development cycle, we would expect that this AE would have to run many tim...
Read more

How to program the Application Engine to return warning status to process scheduler?

By mymithraa -
To program the Application Engine to return warning status to process scheduler:- Perform the below to set the AE_APPSTATUS field properly, in order to return the warning status to process scheduler after the AE finish. 1. Create an AET record for your application engine (AE) program if it does not have any, set it as primary state record 2. Add the field AE_APPSTATUS to the primary state record for your application engine program 3. In the AE program, create a peoplecode action, use the below code to set and return the warning status back to process scheduler accordingly. rem set to 1 to return warning, 0 to return success. AET_RECORD.AE_APPSTATUS = 1;
Read more